ipl-logo

Geo Textiles Essay

1585 Words7 Pages

1.1 History.
Geo-textiles are first used to be an alternative to granular soil sieves. These fabrics are original and still this fabrics are sometimes used as fabric, for this geotextiles are filter fabricate. This geo-textiles are started using in 19th century with Dr.R.J. Barrett. By using geotextiles beside of the pre-cast concrete solid as sea walls, below pre-cast concrete corrosion as the control blocks, intend of large stone repapers, in other erosion control states. Dr.R.J. Barrett has used different method of style of woven fabrics of mono-filament fabric materials, this branded by a comparatively high percentage open area ranges from 6 to 30%. R.J. Barrett also described the need of the importance of soil permeability retention along …show more content…

Mould with base plate is weighted and grease is applied lightly on the interior surfaces of the mould. Water is added to the soil its moisture content is started from 8% or 10% and then mixed thoroughly using the trowel until the soil gets a uniform colour. Compact the moist soil in three equal layers using a rammer of mass 2.6 kg and having free fall of 31 cm. Distribute the blows evenly, and apply 25 blows in each layer. Rotate the collar so as to remove it, trim off the compacted soil flush with the top of the mould, and weigh the mould with soil and base plate. Extrude the soil from the mould and collect soil samples from the top, middle and bottom parts for water content determination. Place the soil back in the tray, add 2% more water based on the original soil mass, and re-mix as in step 3. Repeat steps 4 and 5 until a peak value of compacted soil mass is reached followed by a few samples of lesser compacted soil …show more content…

Bambang Sugeng SUBAGIO, Muhammad “SYAHRIAL FATIGUE CHARACTERISTICS OF AN ASPHALT MIX CONTAINING A GEOTEXTILE” Journal of Traffic andLogistics Engineering Vol. 14, No. 8, June 2009.
v. Kundan Meshram, S.K. Mittal, P.K. Jain , P.K. Agarwal “Application of Coir Geotextile in Rural Roads Construction on BC Soil Subgrade” International Journal of Engineering and Innovative Technology (IJEIT) Volume 3, Issue 4, October 2013. vi. M. Makarchian1 and J. Elyasi2 “Investigation on the Effect of Geotextiles on Pavement Bearing Capacity (Part 1: Experimental Studies)” Amirkabir Journal of Science & Research (Civil & Environmental Engineering) (AJSR - CEE) Vol. 45, No.1, Summer 2013, pp. 15-16 vii. P. Kumar Choudhury, Tapobrata Sanyal “USE OF JUTE GEOTEXTILES IN ROAD, RIVER AND SLOPE STABILIZATION” Proceedings of Indian Geotechnical Conference December 22-24,2013, Roorkee. viii. Mitra Ashis” Application of geotextiles in Coastal Protection and Coastal Engineering Works: An overview” ISSN 2319–1414 Vol. 4(4), 96-103, April (2015). ix. T. SUBRAMANI” Application of Eco-Friendly Geotextiles for Landslide Mitigation in a Part of Ooty Hills, Tamil Nadu” International Journal of Modern Engineering Research (IJMER) www.ijmer.com Vol.2, Issue.3, May-June 2012 pp-579-585 ISSN:

Show More
Related

  • Unidentified Ufo Lab Report

    1222 Words  | 5 Pages

    Fill beaker with water Use the disposable pipette to place water in the graduated cylinder until the unidentified object would be completely submerged in water Record what the measurement of water in milliliters before placing the unidentified object into the graduated cylinder Gently place the unidentified object into the graduated cylinder Record the measurement of the water in milliliters after placing the unidentified object into the graduated cylinder Subtract the measurement of water in milliliters before placing the unidentified object into the graduated cylinder from the measurement of the water in milliliters after placing the unidentified object into the graduated cylinder, this is the volume of the unidentified object Record the volume (the answer you got in step 10) of the unidentified object in the data table Weigh the unidentified object on the scale, this is the mass of the unidentified object Record that number in the data table Calculate the density of the object by dividing the mass by the volume and rounding it to the proper significant figure, Record the density of the unidentified object in the data table Repeat the lab 2 more times and with each experiment record the data in the chart under the correct trial number corresponding with the correct

    Read More

  • The Crucible: Three Boiling Chips

    292 Words  | 2 Pages

    Now, they are ready to start the lab. The empty crucible is weighed by and the weight was recorded. Then the students used a disposable pipet and put close to 4.0 grams of their milk sample in their crucible on the scale. The crucible was then placed back on

    Read More

  • Nt1330 Unit 9 Final Paper

    371 Words  | 2 Pages

    Using coordinates or simple objectives allows the ability to make proper determination. Geographic data allows identifiable information to be offered to subscribers with the encouragement of geographical indicators. Display tools offer a realism of visual effects and the most applicable advantages. Photogrammetry and Remote Sensing, spatial statics and Geographic Information Systems (GIS): Systems of these nature offer geographers collaborative and analyzed information far more unique than traditional research techniques (Geographic Information Systems as an Integrating Technology: Context, Concepts, and Definitions,2015). Lastly, geographic reality and space relation must be gathered using input and output of data and formulaic sequences, but the tools make them applicable to user.

    Read More

  • The Woven Analysis Essay

    501 Words  | 3 Pages

    The Woven is a painting created by Lisa Labarge. This contains the medium charcoal and soft pastel on paper, 40x 27 inches. The painting is located in studio Gallery 234, Pennsylvania, York. According to Labarge, the Woven is a painting that crosses the boundaries of classical and non-classical. Moreover, she specified that the Woven can be made with marble in a classical style.

    Read More

  • Textile Factories Dbq

    245 Words  | 1 Pages

    The textile factories were an unsafe and unheathly place for working class families to work. These factories were unsafe for children to work because the factories would over work the children,give them a insuffient diet and the factories were filled with diseases. For example a testimony from Joesph Hebergram to the Sadler committee he said; ‘i have damged lunges. my lgs muscles do not function properly and will not support the weight of my bones... the doctor told me that it was caused by dust in the factory,from being over worked and a insufficient diet.

    Read More

  • Marshmallows Experiment Lab Report

    1644 Words  | 7 Pages

    The balance of an object mainly involves the dissemination of mass in the object. In a myriad of aspects, balancing yourself or an object can be extremely different especially when we all odds such as gravity is stacked against you. As an example, some teenagers find it hard to balance school, sports and a job. With so much stress and various loads of duties it becomes too heavy for them to handle, and without the right balancing techniques, they can certainly tip over and fall. The same idea applies to the human body and objects in different situations.

    Read More

  • Magnesium Sulfate Heptahydrate Lab Report

    478 Words  | 2 Pages

    This heating and cooling was repeated until there was very little (less than 0.0010 grams) fluctuation in numbers. Vial one had a start weight of 14.7681 and an end weight of 15.4098, meaning the mass of the water was 0.4658. Vial 2 had a start weight of 14.7451 and an end weight of 15.3833, meaning the mass of the water in this sample was 0.4633. The mass of the water was found by subtracting the mass of the vial with the hydrate (the start weight) from the mass after the final heating (the final weight). To then find the percent water divide the water mass by the hydrate mass and multiply by 100 since the number is a percent.

    Read More

  • Mole Mass Lab Report

    372 Words  | 2 Pages

    I. Purpose: To experimentally determine the mass and the mole content of a measured sample. II. Materials: The materials used in this experiment a 50-mL beaker, 12 samples, a balance and paper towels. III.

    Read More

  • Triangle Shirtwaist Factory Essay

    1743 Words  | 7 Pages

    On a warm day in New York City in 1911, tragedy struck. It was an incident that would be written up in newspapers across the country; a horrendous incident that would change legislature, labor laws and hundreds of lives forever. This dreadful event left nearly 150 girls and women dead, and became one of the most murderous fires in the history of New York City. The day was March 26, 1911, and the fire at the Triangle Shirtwaist Factory was an historic one.

    Read More

  • Impact Of Textile Workers In The Industrial Revolution

    729 Words  | 3 Pages

    The Industrial Revolution brought many changes to the lifestyle and way work was completed for citizens of Britain between 1750 and 1900. Machines that provided effective, cheap and fast production of goods began to replace the jobs once held by people. This development effected many groups of workers, but especially those in the textile industry. The introduction of machinery had a significant impact on the lives of these industrial workers due to the low and high demand for goods, unfair wages and unhealthy and dangerous working conditions it inaugurated. The lives of industrial textile workers were significantly impacted by the Industrial Revolution.

    Read More

  • English Textile Factories DBQ

    293 Words  | 2 Pages

    I think that English textile factories were bad for the health of the working class families because in Documents A and C it says that Children were getting hurt constantly, were beaten, over worked, and never had time to eat In document C, John Barley was abused and when someone came to interview them, they had to lie about their treatment , he also worked long hours and their breakfast was very little. When Birley was abused, his boss thought he was dead. When he went to go hit Birley, he quickly put his arm up to protect his head and his boss hit him with all his might. John had A broken elbow and marks. He said “ I bear the marks, and suffer pain from it to this day, and always shall as long as I live…” They also never got fed properly

    Read More

  • Crack In Concrete Research Paper

    1030 Words  | 5 Pages

    Assignment 2 CVE80006 Infrastructure Deterioration Modelling Concrete Crack Diagnosis Assignment The phenomenon of cracking in concrete may depend on several factors such as the amount of loading, rate of bleeding, amount of stress and strain generated in concrete, the composition of concrete and method of fabrication. The cracking of concrete has become severe due to advance construction process which demands high strength structure requiring an increase in stress, strain, and deflection resistance. The cracks in concrete are mainly classified as structural crack and non-structural crack.

    Read More

  • Water Hydration Lab Report

    603 Words  | 3 Pages

    Weight a clean, dry, porcelain evaporating dish on the electric balance and record this mass on an appropriate data table. If the crucible needs to be washed before use, then heat the crucible in the Bunsen burner flame for a few minutes and remove any residual water. Then allow it to cool before continuing. Fill the crucible about 1 gram with the hydrated salt and reweight. Assemble the ring stand, ring, clay triangle, and Bunsen burner

    Read More

  • Garment Industry In Cambodia Essay

    758 Words  | 4 Pages

    Overview of the Cambodian Economy and Garment sector Since the end of civil war and the transition from a socialist regime to democracy regime, and also after it had been shifting from a command and control economy to the free market in the late 1980s, the economic situation of Cambodia began to improve, resulting in increased demand for goods and services in the country and also more attracting inward of foreign direct investment (FDI) in Cambodia during the past two decades. From the report of WORLD BANK (2017), by the last two decades, economy of Cambodia’s GDP growth has grown at an average rate of 7 percent, which driven by garment industry, construction, agriculture, and tourism. In the past, Cambodia was known as the country with an

    Read More

  • Essay On Road Construction

    2638 Words  | 11 Pages

    An introduction to highway building: Although there are many methods to constructing a road, all are based on the principle that geographical objects are removed and replaced with harder and more wear-resistant materials. The pre-existing rock and earth is removed by digging or explosions. Tunnels, embankments and bridge are then added when necessary. The material that the road is being constructed from is then laid by various pieces of equipment, which will be looked at in greater detail in this assignment. The construction management of roads has become increasingly more difficult as larger structures are constantly being required in increasingly short amounts of time.

    Read More

More about Geo Textiles Essay

Open Document