ipl-logo

Gripper Structural Anchor

171 Words1 Page

The gripper structure anchor of the top cable assembly is attached with the appropriate anchor. The gripper could be screw attached onto an expansion anchor or screwed direct to the structure. The next step is to thread the aircraft cable through the gripper anchor cap and completely screw the cap into the gripper structure anchor. The aircraft cable hangs freely at each anchor and the bottom cable assembly is attached to the canopy before raising the canopy and attaching both assemblies together as shown in Figure 48. Figure 41 - Gripper Structure Anchor
Canopy Installation - Screw in Cap This installation addresses the screw in cap method. Although, this method is similar to the spiral anchor method there are differences which must be

Show More
Related

  • Rock Solid Industry Parts Executive Summary

    1884 Words  | 8 Pages

    Executive Summary Rock Solid Industry Parts, Inc. is a family owned company planning to move in a new direction to success. As a company moving towards a new direction employees need to change the way they work which represents the first challenge. After the leader of the company or CEO communicates the vision or goal with solutions to probable risks, employees should be able to apply the strategy accordingly in every department. Introduction/Thesis Rock Solid Industry Parts, Inc. is a small family owned company that is planning to grow from 50 to 100 employees in the next three years. In preparation for this goal the CEO consults the IT director of the options to modernize its IT/IS infrastructure.

    Read More

  • The Engineering Of A Trebuchet Essay

    748 Words  | 3 Pages

    The Engineering of a Trebuchet To understand all the works and Physics behind a trebuchet, you must first understand all the individual parts of the trebuchet. Corresponding with most machines, the trebuchet is made up of different parts each having their own unique function. The five parts of the trebuchet are; the frame, the arm (or beam), the counterweight, the sling, and the guide chute (“How the Trebuchet Catapult Works”). Additionally, corresponding with most machines each part of the trebuchet can manipulated to create a different output.

    Read More

  • Fernand Leger Bridge Of The Tug Analysis

    886 Words  | 4 Pages

    In New York City the decade of the 1920s was a prosperous and carefree time for many people that featured an economic boom in regards to automobiles, radios, and telephones. It was a decade of change for many reasons and for Fernand Leger it was a decade of demobilization with the theme of the city. Leger used this time to focus on the city and make it the inspiration for his new line of paintings. He wanted people to embrace the industrial time and using it in his paintings gave the topic emphasis. In Fernand Legers painting, The Bridge of the Tug, he uses sharp, simple shapes to depict his view of New York in a way that is chaotic and machine like in order to encourage society to embrace the new industrial era.

    Read More

  • Chrystal Observation

    631 Words  | 3 Pages

    Full bond/bond additional: On our bonds Chrystal set up completely and efficiently. Which included writing all steps to bond on the tray cover to refer back to. She pumised and green stoned with a slow speed which she completed in a timely manner, had great ISO, when placing etch (instructed not to scrub and explained it could damage enamel rods) after doing so or had a great chalky appearance, (when placing solo explained we only wanted a light layer so the brackets wouldn 't slide) when placing she knew which bracket would be next gluing time had greatly improved. She preped for turbos and began to place but requested help to make a bitting surface after appt.

    Read More

  • Myp101 Week 1 Friction Research Paper

    770 Words  | 4 Pages

    Suraj Singh Ms. Charlie Science MYP 1 19 November 2014 Has the concept of Friction helped in modernization mankind and the world? Friction is when two surfaces or object are in contact and rub against each other. Friction is something that we use every minute of our life. Without friction, we wouldn’t have the ability to complete virtually anything.

    Read More

  • Palm Spinners Research Paper

    403 Words  | 2 Pages

    Do you get your fingertips constantly having to be occupied? Well nail-biters, desk-drummers and pen-clickers we've the perfect fidget gadgets to assist you. The brand new fidget spinners on the marketplace are gripping the interest of men and women' and children's equally! Just what exactly are they?

    Read More

  • Horse Grooming Techniques

    642 Words  | 3 Pages

    Make sure the band is flat against the horse's rib cage but not to close to the front legs. Using the long strap called a latigo, run it through the dee ring on the cinch to make it snug against the horse. Next you run the latigo back through the saddle's dee ring, keeping it snug. If the latigo is very long you can repeat looping the strap through the dee rings again. To tie the securing knot, you will cross the loose end over the layers and run it through the back of the dee ring, making a small loop.

    Read More

  • Slap Repair Case Study

    52 Words  | 1 Pages

    Hi Jacob, Thank you for your overview. Your protocol seems a faster, accelerated protocol for someone with RTC and SLAP repair. Your patient had also SLAP repair 1 year ago right? What was his pain level before and after rehabilitation? And, how many visits (average) did he need to reach phase IV?

    Read More

  • Trampoline Research Paper

    582 Words  | 3 Pages

    By laying out the pieces in a circle you get a feel of how big the trampoline is. Make sure that when you lay out the ring foundation of the trampoline u lay them out properly. Attach each part of the ring first before attaching the legs. Once the ring has been attached altogether, assemble the legs and attach them to the ring. For bigger trampolines make sure that the squares an on the outside of the ring.

    Read More

  • Unlikeliest Hero In Class Analysis

    279 Words  | 2 Pages

    imagine dashing through swings with twenty pounds strapped to your back, running to get the best time to win the prize…..donuts. thats how it felt running through the obstacle course for mrs. rothe this quarter. We were reading The Unlikeliest Hero in class. In the spirit of the book we formed squads and did obstacle runs and calisthenics. we werse also graded on cleanliness and punctuality.

    Read More

  • Gaffer's Tape

    331 Words  | 2 Pages

    • Pull the cable tight, and place another piece of tape across the cable below the power outlet. • Leave enough slack between the tape and the outlet, so that the cord does not come out of the outlet. • Next, beginning at the first piece of tape, place a piece of gaffer's tape lengthwise on top of

    Read More

  • How To Change A Flat Tire Essay

    934 Words  | 4 Pages

    Applying the wheel wedges: This is the first step and it ensures that your vehicle is stable enough. They are placed either in front or at the back of the tires. When changing a back tire, place them in front of the front tires and when changing the front tire, place them behind the back tires. Removing the wheel cover: If your vehicle has a hub cap covering the nuts start by removing it. Use a screw driver and lift the wheel cover at the point where the edge meets the wheel and repeat this process until the cover completely comes

    Read More

  • Why The Pegs On The Violin Are Used To Create String Tension?

    276 Words  | 2 Pages

    Step 1 Loosen the peg by turning it counterclockwise. This will unravel the string. Step 2 Retighten the string by gently pushing the peg in while turning it clockwise to both create string tension and

    Read More

  • Disadvantages Of Dance Poles

    818 Words  | 4 Pages

    Say you own a pole on a platform, that’s secured by a square wooden base.

    Read More

  • Pediatric Endocrine Imaging: A Case Study

    1504 Words  | 7 Pages

    Pediatric Endocrine Imaging – Evaluation of the pituitary gland and a child with precocious puberty. Dr Priscilla Joshi Major Endocrine glands, which may need evaluation in children, are • Pituitary : hypophysis- hypothalamus axis • Thyroid • Parathyroid • Pancreas • Adrenals • Gonads- ovaries and testes This chapter would deal predominantly with imaging of the pituitary gland as well as evaluating a child with precocious puberty.

    Read More

More about Gripper Structural Anchor

Open Document