AGRICULTURE is the need of most of the Indians livelihood and it is one of the main sources of livelihood. It also has a major impact on economy of the country. A major quantity of water is used for irrigation system and therefore 85% of available fresh water resources are used for yielding agricultural crops. This resource of water will decrease day by day and consumption of water will dominate and increase more than 85% in upcoming half century. This is due to the high growth in population due to this tremendous growth in population there is huge demand for food. Agriculture is the main source for food production. Using science and technology we need to implement a method by which there can be limited consumption of water.
Till date many methods have come into existence where water can be limitedly consumed. A method where monitoring water status and based on status of water whether it is high or low irrigation is scheduled which is based on canopy temperature of plant, which was captured with thermal imaging. Another method is making use of information on volumetric water content of
…show more content…
It is preferred by engineers because it uses very small amount of electric power. Liquid crystal display (LCD) offers several advantages over traditional cathode ray tube that makes them ideal for several applications. Of course LCD’s are flat and they use only a fraction of power required by cathode ray tubes. They are easier to read and more pleasant to work with for long periods of time. There are several tradeoffs as well, such as limited view angle, brightness and contrast, not to maintain high manufacturing cost. 16x2 LCD is used in this project to display data to user. There are two rows and sixteen columns. It is possible to display 16 characters on each of the 2 rows. It has registers, command and data
2. Add 8cm³ of sodium carbonate to each tube using a measuring cylinder. 3. Measure out the strontium nitrate for each boiling tube and add it (boiling tube 1 contains 1cm³, test tube 2 contains 2cm³ and so on). 4.
Next, about 10 mL of both solutions, Red 40 and Blue 1, were added to a small beaker. The concentration of the stock solution were recorded, 52.1 ppm for Red 40 and 16.6 ppm for Blue 1. Then, using the volumetric pipette, 5 mL of each solution was transferred into a 10 mL volumetric flask, labelled either R1 or B1. Deionized water was added into the flask using a pipette until the solution level reached a line which indicated 10 mL. A cap for the flask was inserted and the flask was invented a few times to completely mix the solution. Then, the volumetric pipette was rinsed with fresh deionized water and
By reading the new volume of the liquid substance amount one will then subtract the initial milliliter amount from the final volume reading, thus giving you the volume of the rock sample. Using the mass of the sample rock obtained one will then divide the final volume reading unveiling the density of the
B) Briefly describe each method, including the specific types of scientific tools and equipment used. Modified Mercalli Intensity Scale:
Characteristic Property- Test 2- Density Materials: Triple Beam balance, distilled water, graduated cylinder, unknown 6 Procedure: first we found the mass of the empty graduated cylinder and then its mass with the now distilled unknown. After subtracting the mass of the graduated cylinder, we were able to find the volume. For every 1mL=1cm³ so there we had the volume found with the graduated cylinder. We divided the mass by the volume in order to get the density Data: We found that the density of our unknown was 0.76 g/cm3.
Our first method was to weigh the glass by putting it in a graduated cylinder of water and placing the glass inside and to observe the lever to with the water rose after first recording the original state of the water. The second test we preformed was to measure the glass and use it’s dimensions to determine the density. This procedure taught me how problem solve effectively and scientifically using information I previously learned in both chemistry and mathematics and applying it to this problem. This also gave me the ability to test the effectiveness of my experiment and decide which one was more proficient at producing an accurate test of the density of the glass. We continuously referred back to the original request of the experiment, making sure our goals aligned with the problem at hand, determining
The appearance after this period resulted in another color change back to white. The crucible, lid, and hydrated copper sulfate was weighed again to calculate the mass of water lost by dehydration (described in table 1.3). This was done by subtracting the final mass by the initial mass of the crucible, lid, and compound. The mass of the crucible would remain unchanged while the mass of the compound would be altered. This trial was repeated 3 times and 1 extra set of data was taken from 2 separate groups to include
2 ½ tab divided in 2 pc 19.5 49.5 ½ tab divided in3 pc 21.4 37.11 ½ tab 19.5 53.22 3 ½ tab divided in 2 pc 19.6 48.41 ½ tab divided in 3 pc 20.6 37.30 AVG ½ tab 18.9 53.51 ½ tab divided in 2pc 19.5 49.09 ½ tab divided in 3pc 20.9
Farmers will reduce the daily amount of water they use on crops and cut it by 35%. Another way to save water is to stop
Materials: The materials that I will be utilizing during these experimentations are three to four ice cubes, one cup for measuring, six unblemished cups, one stopwatch, one hot water source, three tablets of Alka-Seltzer, one thermometer that measures from negative
I. Match each term with the appropriate definition. Type the letter that defines the computer term. COMPUTER TERM J Specialized Computers H Hardware
Utilizing the method that the experimenters have come up with, the procedure isolates the variable being tested, which is the paper towel brand. By not changing other aspects of the procedure, other factors have a lower chance of affecting the accurate results of the answer to the main question. Additionally, the method is a quick and simple experiment, causing no use of excessive time than the provided duration. Within the first minutes of the experiment, the experimenters and the advisor realized that the method did not really provide accurate results due to merely estimating the numbers without the use of a graduated cylinder. Changing that aspect of the procedure by using a graduated cylinder to measure the amounts of water instead helped
4. Measure your bears from top to bottom (length), from side to side (width), and from front to back (height). Use your measurements to calculate the volume. Record your data in the data table. 5.
So, because of the availability of clean water is being abused, the problem of wasting water started to emerge. Some people thinks that with all the water on our plant’s surface, why are many so worried about water preservation? People who waste water think that it’s from their right to have plenty of water. If one mediates the world around, he/she should have observed that all creatures on earth need water to survive. Furthermore, the shortage of water in the body of any living creature happen to cause health problems and even death.
TABLE OF VARIABLES Independent Variable Method of measurement Concentration of HCl