ipl-logo

Nt1310 Network Cabling Research Paper

703 Words3 Pages

data from because it is on the online even your computer does not work still we can use another computer or smart mobile phone and can get our work effectively.

C. Explain the purpose, relative function and transmission speed of the following Network cabling including: • Coaxial cable: Coaxial cable is used for the network communication, Video and audio which means this coaxial cable can be connected to the TV to get the signal from the satellites or music player system.

There are 2 type of network cabling which is Thicknet and thinnet (diameter is about 0.25 inches or 0.64 cm) this can be used to connect any type of the network cables. Thicknet cabling is referred 10base5 system which is 10 Mbps of speed and 500 meter of the distance but the Thicknet cables is used for LAN network. Thinnet cable referred 10base2 which is 10 Mbps and 200 distances and it’s used for LAN network. Difference between Thicknet and thinnet is different length of the coaxial cabling within same speed of transmission.

Transmission speed depend on the functions for example, in high power- frequency transmission there will …show more content…

It works third way where it sends information coded in a beam of extremely thin strands glass or plastic pipe. Each strand is less than tenth as thick as human hair and can carry 25,000 telephone calls. At the beginning, this technology used in transmitting telephone calls at the speed of light (186,000 miles or 300,000km). The fibre can be protected from the heat, sun, cold and ultraviolet rays. It can also use any type of network. For example, if we connect the optical cable to the Television, we will receive a better quality sound and there is no sound degradation. The fibre optical cable is average transmission speed about 10Gbps. The function of the optical cabling is light guide with the data sends via light

Show More
Related

  • Nt1310 Unit 5 Circuit Paper

    1668 Words  | 7 Pages

    3. Insulation material: made from XLPE and isolate between the three phases, its thickness is about 5.5 mm along the cable 4. Outer semiconductor: uniformly distribute the voltage on the surface of the insulation 5. Earth layer: made from copper, used to ground the cable, in case of short circuit it protect the cable by leaking the short circuit current into the ground, its thickness is about 25mm2 area 6. Filling: synthetic fibers used to make the cable circular and to fill the gap between the phases 7.

    Read More

  • Nt1310 Unit 1.3 Network Analysis

    684 Words  | 3 Pages

    1.3 How do local area networks (LANs) differ from wide area networks (WANs) and backbone networks (BNs) Local area networks are limited within an organization Wide area networks extend over a large geographical distance and may be privately owned or rented Backbone network are the part of network infrastructure that feeds the connected networks 1.8 Describe the seven layers in the OSI network model and what they do. Application – this layer is specific to applications and provides services such as email, network software services and file transfers Presentation - In this layer, the data is formatted in a schema that network understands, and also manages data encryption and decryption Session – this layer establishes and controls the data communication between

    Read More

  • Nt1310 Unit 3 Data Center Framess

    788 Words  | 4 Pages

    The SIFS( Shortest Inter-Frame Space),derives the time between the last transmission and high priority transmissions such as positive acknowledgments(ACKs),Clear-To-Send(CTS)frames,polling responses, continuation frames in a burst transmission. priority is given to the positive ACK frames so that a station which has just completed the reception of a frame can give immediate feedback to the sender. RTS and CTS frame coordinate correspondence between sets of stations so that different stations know not the medium to be free for the time of the exchange .This is one of the reasons for why the control frames have priority over normal data transmissions. If a station finished transmitting a frame and has enough time left to send an additional frame, it is allowed to send after a SIFS.

    Read More

  • Nt1330 Unit 12 Research Paper

    826 Words  | 4 Pages

    Hadoop [8] is an open source implementation of MapReduce programming model which runs in a distributed environment. Hadoop consists of two core components namely Hadoop Distributed File System (HDFS) and the MapReduce programming with the job management framework. HDFS and MapReduce both follow the master-slave architecture. A Hadoop program (client) submits a job to the MapReduce framework through the jobtracker which is running on the master node. The jobtracker assigns the tasks to the tasktrackers running on many slave nodes or on a cluster of machines.

    Read More

  • Nt1330 Unit 3 Assignment 1 Network Analysis

    1448 Words  | 6 Pages

    HOMEWORK ASSIGNMENT 1 PROF: TOM WILKES FALL 2015 AKHILA DAMERA 1. What is the purpose of an interrupt? Answer: An interrupt is a signal from software or hardware. It indicates the occurrence of an event.

    Read More

  • Nt1310 Unit 3 Dental Services

    452 Words  | 2 Pages

    In Ethernet data is send in form of packages, to control

    Read More

  • Nt1330 Unit 6 Research Paper

    971 Words  | 4 Pages

    I am going to explain the current methods and protocols we use in a LAN environment to provide a high level of redundancy, such as EtherChannel, FHRP (First Hop Redundancy Protocols) and STP (Spanning Tree protocols). I will briefly explain how the protocols work & then discusses the latest implementations of the protocol and the environment you would expect to see them working in. The STP is a protocol that prevents loops from occurring in a switched LAN environments when a device has multiple interconnected paths. The protocols works by sending BDPU messages across in the interconnected devices, detects the loop then removes it from the topology by shutting down the port.

    Read More

  • Ito 540 Unit 3

    859 Words  | 4 Pages

    Answer 16: Frame relay would automatically assume that fiber-optics will be used and there will be no errors. It uses the do nothing form of error control. Answer 17: One packet can be sent using Stop-and-wait protocol at one time. Answer 18: The ACK in Stop-and-wait protocol acknowledges that there have been no errors during transmission of data.

    Read More

  • Nt1310 Unit 6 Network Analysis

    591 Words  | 3 Pages

    This will allow us to create a secure connection to the network over the internet. With this design the campus will have a much more reliable network to its

    Read More

  • Nt1310 Unit 2.1 Networking Research Papers

    431 Words  | 2 Pages

    2.1 AWS Networking AWS provide a kind of networking services that also provide private network connections to the cloud, scalable DNS and tools to make logistically solitary networks. There are also have prevalent networking services comprise the Amazon Virtual Private Cloud (VPC) and Amazon Direct Connect. Amazon VPC generates a logically solitary set of Amazon EC2 for example which can be connected to current network using VPN connection. Amazon VPC generates a private cloud inside AWS, while deposition built-in security with security groups and network access control lists. When using Amazon EC2, VPC is free.

    Read More

  • Nt1330 Unit 3 Network Analysis Paper

    1267 Words  | 6 Pages

    In order to access a UNIX system, and use it , you need to connect to the system. You can login: Locally Remotely Login Types In general, there are two ways: Command-line Login GUI Login Connecting Locally Connecting locally means, you are directly logging into the UNIX system. Network connectivity is not required.

    Read More

  • Nt1310 Unit 3 Network Analysis

    336 Words  | 2 Pages

    1. I will be able to learn various networking protocols for routing and switching like OSPF, RIP, EIGRP and BGP. As working in the field of network security is my career goal, learning these protocols during my Co – op will help me introduce to the base of core networking. 2. I will be able to design architecture for a communication network.

    Read More

  • Nt1330 Unit 9 Final Project

    1313 Words  | 6 Pages

    The University of California, Riverside is highly known for its incredible Bell Tower, but while the Bell Tower is a great site the campus offers a one of a kind Botanical Garden. The Botanical Garden has been around since the 1960's and till this day is always improving. The Botanical Garden welcomes people to experience it's blooming flowers, hiking trails, plants, and wildlife. While the Botanical Garden offers a beautiful sight it also serves other purposes, to serve the community by contributing to research for the university, volunteer options, and fundraisers to benefit the university's programs.

    Read More

  • Essay On Computer Network Topology

    904 Words  | 4 Pages

    The fundamental cable goes about as a backbone for the system. One of the computers in the system ordinarily goes about as the computer server. The main advantage of bus topology is that it is very easy to connect a PC or peripheral device. The second advantage is that the cable necessities are generally little, bringing about lower expenses. One of the disadvantages is that if the fundamental cable breaks, the whole system goes down.

    Read More

  • Switch Technology Research Paper

    3619 Words  | 15 Pages

    The figure shows that the members of V LAN can physically connected to the same or different switches. The LAN switch used as a transmission carrier so that the members of VLAN can communicate with low latency and high speed rate. Membership control, topology independence and high-speed LAN internal connection technology provide a number of advantages for

    Read More

More about Nt1310 Network Cabling Research Paper

Open Document