Nt1310 Unit 4 Lab
a). Based on the observation, we assume that the distance between two stations is 0.375 KM Mean time to send = propogation time + transmission time = 375m. + 1000bits 200 x 106 m/sec. 10 000 000 bps. = 102 μsec. b). If the two stations begin the transmission at the same time the signal will interface after exactly 250m. Tinterface = 375m 200 x 106 m/sec. = 1.875 μsec T(bit - times) = 107 x 10-6 x 1.875
Nt1330 Unit 1 Case Analysis
1295 Words | 6 PagesBU275 Assignment 2 Equations Question 1 A Station 1: Prep Inter-arrival time is the time between consecutive arrivals of the customers. Because the inter-arrival times are exponentially distributed, customers arrive at random times. The mean is 100 customers/ hours. This indicates that a customer arrives every 0.6 minutes.
Nt1310 Unit 6 Lab
227 Words | 1 PagesThe power spectral densities ($PSD$) of the gas jet centerline $C^*(t)$ for the tests in Tab.\ref{Table} were computed via $FFT$, and collected in Fig.\ref{Spectra}. For plotting purposes, the frequency domain $f_j$ is limited to $f_j=150 Hz$, and the $PSD$ in each graph is normalized with respect to the maximum $PSD$ detected within the three tests. Regardless of the stand-off distance $\hat{Z}$, for $\hat{Y}=0$ the response of the jet to the membrane motion is the superimposition of a harmonic response $f_h$ and a higher frequency $f_f$, which is not affected by the membrane motion. Noteworthy, $f_f$ scales with the standoff distance and leads to a constant Strouhal number $St_Z= f_f Z/U_j\approx 0.08$, not far from the $St_Z=0.12$ \cite{Vshape}
Nt1310 Unit 3 Data Center Framess
788 Words | 4 PagesThe DIFS, or DCF Inter-Frame Space, is the base time taken by any station yet not the organizer must hold up to transmit. On the off chance that the medium is detected to be free, after a DIFS, a station may begin decrementing its backoff counter. The PIFS is shorter than the DIFS so that the central coordinator can take control of the network whenever The EIFS, or Extended Inter-Frame Space, is the minimum wait time for a station that receives corrupted frames or other errors. The EIFS is frequently variable relying upon the type and number of mistakes. Prior to the station has the opportunity to transmit once more, the EIFS time is intended to give another station time to ACK the casing that was gotten and deciphered as degenerate.
Nt1210 Unit 12
321 Words | 2 PagesChildren in this group were provided with base-10 and unit blocks. Each base 10 block is 1 cm × 1 cm × 10 cm in size. Each unit block is 1 cm × 1 cm × 1 cm in size. The research assistant gave explicit demonstrations of how to use both base-10 block and unit blocks to construct two-digit number. First, the research assistant placed out ten unit-blocks in a line and then put a base-10 block along to the ten unit-blocks.
Nt1310 Lab 7.4
458 Words | 2 Pages7.4.1.1 Dielectric withstanding voltage The purpose of this test is to prove that a connector can operate safely at its rated voltage and will be able to withstand momentary over potentials due to switching, surges and other similar phenomena. The applied voltage can be either AC or DC. The voltage should be applied across the two closely spaced contacts as well as between a connector shell and the contacts closest to the shell. The test voltage in the case of coaxial connectors shall be applied between the inner and outer conductor. The voltage should be ramped up uniformly from zero to rated value.
Nt1310 Unit 4
984 Words | 4 PagesIn our simulations, there are one MeNB and one SeNB, and the distance between MeNB and SeNB is 1 km. All UEs are assumed to have dual connectivity capability, and their initial locations are randomly assigned. A UE can connect to the SeNB if the detected signal strength on that SeNB is larger than $-75$ dBm. Each UE is configured to have one bearer, and the traffic type of the bearer is constant bit rate (CBR). For a UE, it may receive data from MeNB, SeNB or both of MeNB and SeNB depending on its location or the decisions of our traffic scheduler.
Nt1310 Unit 7 Lab 7
91 Words | 1 PagesLab 7: Moon Phases was designed to measure the relative position of the Sun and Moon over the course of one phase cycle (i.e. one month, 29.5 days) The idea for Lab 7: Moon Phases was to examine how the illumination of the moon by the Sun produces the different phase cycles we see as the Moon rotates around Earth and as the Earth rotates around the Sun. The observations of the Moon were taken on four different days in the month of February to March capturing four different Moon Phases.
Nt1210 Lab 10.1
831 Words | 4 PagesUnit D Summary: Light and Geometric Optics 10.1 : Light and The Electromagnetic Spectrum Chapter 10.1 covers light and the electromagnetic spectrum. This chapter starts off by describing how light is a form of energy that travels in waves. The properties of said waves include a crest (the highest point of the wave), the trough (the lowest point of the wave), and the rest position (the level of a wave without energy).
Nt1310 Unit 1
410 Words | 2 PagesWith widespread use of internet services, the network scale is expanding on daily basis and as the network scale increases so will the scale of security threats which can be applied to system connected to the network. Viruses and Intrusions are amongst most common threats that affects computer systems. Virus attacks can be controlled by proper antivirus installation and by keeping the antivirus up to date. Whereas any unauthorized access in the computer system by an intruder can be termed as Intrusion and controlled by IDS. Intruders can be grouped into two major categories which are external and internal Intruders.
Nt1330 Unit 1
755 Words | 4 Pages1. List and explain the top 5 factors that are required, at a bare minimum, to make an application secure. Security architecture, authentication, session management, access control, and input validation are the top five factors that make an application secure. Security architecture: OWASP verification requirements in security architecture verify all the application components and libraries that are present in the application are identified. A high level architecture of an application must be designed.
Nt1310 Unit 4 Work
425 Words | 2 PagesThe objective of this piece was to create something meaningful to me, that will flow together well by using audio files. I’m a huge fan of the piano, so I knew that I wanted to incorporate a piano in the piece. Surprising enough the main part of the whole piece is the pinaoloop2 on a loop. The work process for this piece primarily involved getting the audio samples that will work nicely around my main piece which is the pianoloop2. After obtaining the audio files, the major software that I use to get the sounds together was Audacity.
Nt1310 Unit 1
552 Words | 3 PagesThe three features from Unit 1’s reading I have chosen are Cutting, Copying and Pasting Text; Setting the Page Layout; and Removing Blank Paragraphs. Each of these three features makes every day word processing activities easier, saves time, and reduces the waste of paper. Cutting, copying and pasting text makes typing the same thing to multiple people or companies easier by copying the text and pasting it to different documents. You can edit the text by cutting or copying what needs to be changed from each document.
Nt1310 Unit 4
1058 Words | 5 PagesBreak Point 6.2 I think that the students are trying to describe what most people cannot: the effect that music has not on our minds, but our bodies. Because the mind is not involved in this physiological process, one can only begin to describe why we get "pumped," why our heart rates increase or why our moods change when we hear a certain piece of music. In the conversation in Chapter 6, each student seems to have a different way of describing how music makes them feel, which supports my belief that each student has a unique physiological approach when listening to or performing music that is unlike that of anyone else. As the chapter mentions, there is no true explanation as to why some people get goosebumps when a certain song plays and others do not. Personally, my musical tastes are all across the board, and change
Nt1310 Unit 6 Lab Report
631 Words | 3 PagesIn this lab there were five different stations. For the first station we had to determine an unknown mass and the percent difference. To find the unknown mass we set up the equation Fleft*dleft = Fright*dright. We then substituted in the values (26.05 N * 41cm = 34cm * x N) and solved for Fright to get (320.5g). To determine the percent difference we used the formula Abs[((Value 1 - Value 2) / average of 1 & 2) * 100], substituted the values (Abs[((320.5 - 315.8) /
Nt1310 Unit 7
356 Words | 2 Pages1. What were your results for the test? Were these results surprising to you? Why or why not? a.
More about Nt1310 Unit 4 Lab
Nt1330 Unit 1 Case Analysis
1295 Words | 6 PagesNt1310 Unit 6 Lab
227 Words | 1 PagesNt1310 Unit 3 Data Center Framess
788 Words | 4 PagesNt1210 Unit 12
321 Words | 2 PagesNt1310 Lab 7.4
458 Words | 2 PagesNt1310 Unit 4
984 Words | 4 PagesNt1310 Unit 7 Lab 7
91 Words | 1 PagesNt1210 Lab 10.1
831 Words | 4 PagesNt1310 Unit 1
410 Words | 2 PagesNt1330 Unit 1
755 Words | 4 PagesNt1310 Unit 4 Work
425 Words | 2 PagesNt1310 Unit 1
552 Words | 3 PagesNt1310 Unit 4
1058 Words | 5 PagesNt1310 Unit 6 Lab Report
631 Words | 3 PagesNt1310 Unit 7
356 Words | 2 Pages