Direct current Essays

  • Essay On Smart Grid

    3724 Words  | 15 Pages

    INTRODUCTION A smart grid is a power network which is based on digital technology is used to supply power, via two-way digital communications. A smart grid system allows for monitoring, analysis, control and communication within the supply chain and helps improve efficiency, reduce energy consumption and cost, and maximize the transparency and reliability of the energy supply chain. The smart grid was introduced with the aim of overcoming the weaknesses of conventional electrical grids by using

  • Nt1310 Unit 3 Report

    1523 Words  | 7 Pages

    different testing procedure and provide the detailed observation. P1.1 Your report/observation must contain the following information. 1) Test the semiconductor devices used in the both circuits in figure 1 and figure 2. 2) Record the measured voltages, currents at different points and suggest about correct functionality. 3) Write down the detail report for testing the semiconductor circuits by using two different methods. Figure-1 DC Power Supply Circuit Figure-2 Single Stage Amplifier 3.1 Introduction

  • Research Paper On Noise Pollution

    2835 Words  | 12 Pages

    Analysis of Noise impact on various parameters by Response Surface methodology for optimum Safe Working Area N.Boominathan1, G.K.Vijayaraghavan2, R.Kathiravan3 1Research scholar, Periyar Maniammai University, Vallam, Thanjavur, Tamilnadu. Email:nboominathan@gmail.com 2Principal, Dhaanish Ahmed college of engineering, Padappai, Chennai 601 301. Tamilnadu Email: haigkv@yahoo.com 3Professor and Head, Aerospace engineering department, Periyar Maniammai University, Vallam, Thanjavur, Tamilnadu. Email:

  • Finite Element Analysis: Analysis Of Chain Link

    729 Words  | 3 Pages

    CME 434 - Finite Element Analysis Project Title: Analysis of Chain Link By: Anuj Salke (UIN 660484908) Sujay Khamitkar (UIN 662253535) Problem Statement: To study the stresses that occurs in a chain link when it is subjected to loads and to verify the results analytically. The aim of the project is to calculate the stresses induced in a chain link analytically and verify if these results are same with the results obtained from ANSYS. We found that they are not exactly

  • Advantages And Disadvantages Of Cockpit Automation

    1211 Words  | 5 Pages

    COCKPIT AUTOMATION A Good Servant but a Bad Master Introduction 1. With the advent of modern technology, the use of computers has become inevitable in the completion and performance of a particular task. While automation has proven to improve the speed of completion of a job, it drastically affects the "operator" whose task shifts from being the "performer" to being the "observer". This is where the issue of "complacency" sets in. With this major revolution, one may ask if the introduction of

  • Suncrest Solar Case Study

    1079 Words  | 5 Pages

    Suncrest Solar Data & Facts Availability - California Contract Length - Undisclosed Payment Options - PPA only Setup Fees - None Online Monitoring - Yes Warranty - NA, they only offer a PPA option Finance Options - NA, they only offer a PPA option Time in Business - 2010 BBB - Not accredited, A+, http://www.bbb.org/sdoc/business-reviews/electricians-residential/suncrest-solar-electric-in-tustin-ca-172013659 Introduction Welcome to our Suncrest Solar review! Suncrest Solar was founded in 2010 and

  • Capacitor Lab Report

    9386 Words  | 38 Pages

    INTRODUCTION 1. INTRODUCTION 1.1 Fundamentals of capacitor Capacitor is very useful component in the field of engineering and it is used in various electrical and electronic circuitries. Capacitor stores energy in the form of electric field. Capacitor also known as condensers which stores energy when charge and release energy when discharge . There are different forms of capacitors which are used widely, but common thing about this all capacitors is that they are made of two conductors

  • Power Direct Marketing

    502 Words  | 3 Pages

    Short Description Power Direct is a home to a massive range of home electronics and appliances in the UK. Having many years of experience, the company offers TV and video systems, audio and HiFi systems, kitchen appliances and many more products to make sure you can find everything you need for your home. With some of the most professional and friendly customer support staff, Power Direct is proud of not only their excellent quality products, but excellent customer service too. From radio and television

  • Conventional Machining

    746 Words  | 3 Pages

    This chapter focuses on AISI A2 material, its properties and composition. A brief explanation is provided about wire electrical discharge machining (WEDM) process, its process parameters and its various advantages and disadvantages. The knowledge of these will be beneficial in understanding the different effects of the process parameters of the WEDM on the response parameters. 1.5 NON-TRADITIONAL MACHINING In Conventional machining or traditional machining the tool required is harder than the work

  • V.: ABC Reference Structure-Based Control

    1460 Words  | 6 Pages

    in an independent way. In the suggested control scheme, the power calculation and harmonic abstraction are not required since the harmonics, unbalances, disturbances, and displacement would be compensated. The SAF has a current loop in order to make sure a sinusoidal grid current synchronized with the grid voltage. The PAF has a voltage loop in order to ensure a balanced controlled load voltage with small harmonic distortion. The SAF and PAF control loops are independent from each other since they

  • Nt1310 Unit 5 Lab Report

    1051 Words  | 5 Pages

    DC-link voltages, 2) reduced output current distortion and 3) reducing capacitor RMS current. The motor input currents have been regulated by controlling the output voltages of the inverters. The control strategies are implemented using OPAL-RT based real time prototyping tool. Operational time-step is kept constant at 25 µs. The parameters of the experiments are as follows: dc-link

  • Ohm's Law Lab Report

    1206 Words  | 5 Pages

    Usually, it is possible to calculate the currents and voltages in a circuit by solving a set of equations, the calculations are required to design a safe circuit.and this is one reason why advanced mathematics is so important in the field of electrical engineering. The circuit equations can be determined using Ohm’s Law, which gives the relationship between voltage and current in a resistor (V=IR), and Kirchhoff’s Current and Voltage Laws, which govern the currents entering and exiting a circuit node

  • Jem Finch Character Analysis

    826 Words  | 4 Pages

    Jean Louise Finch (Scout) is the daughter of Atticus Finch and the sister of Jem, she is also the main character and the narrator of the story, and she grows physically and morally throughout the book in positive and negative ways. There are multiple events in the story that changes her, they develop her morality too. For example her fear of the Radleys, Atticus’ parenting and how Jem and Dill’s friendship is larger than her with them. The world of ‘To Kill A Mockingbird’ was placed in the past,

  • Empowerment In Nursing

    1453 Words  | 6 Pages

    3.0 Discussion on the important for nurses to be more visible   Barker emphasizes that to be appropriately valued in health care and by the public, it is critically important for nurses to be more visible "in every role and place of employment."Barker E,2001. 3.1 Power and empowerment Power and empowerment are connected to the image of nursing.Nurses typically do not like to talk about power,they find this to be philosophically different from their view of nursing.Power is about control to reach

  • Overview Of Global Green Book Publishing

    942 Words  | 4 Pages

    by 40, you would find the full-time equivalence for that task and job type. I would have GGBP also identify any current part-time employees that could be transitioned into a full-time role. Then I would compare the needed manpower to what GGBP currently has to find where they will need to hire. Once hired, I would have the new full-time employees onboarded and trained while the current part-time employees continue to work. There will be an overlap of employees, but this will allow time for the new

  • What Are The Ethical Issues Surrounding Organ Allocation

    1643 Words  | 7 Pages

    The aim of this assignment is to describe an ethical dilemma from nursing practice and by using an ethical framework critically analyse the main issues arising from the problem. The essay will discuss the definition of ethics and it will briefly discuss the main theories of ethics. It will examine an ethical dilemma surrounding organ transplantation and it will analyse the conflicts by using the main principles of ethics. Finally, it will give recommendation in relation to ethics and its application

  • Acute Care Case Study

    592 Words  | 3 Pages

    According to the Office of Statewide Health Planning and Development, in 2014 the number of discharges in Yolo that had to do with Acute Care was 14,371. Chemical Dependency Recovery Care was 11, Physical Rehabilitation Care was 106, Psychiatric Care was 1,075, and Skilled Nursing was 21 which turns out to be a total of 15,584 discharges in all of YOLO county in 2014. Of the 14,371 discharged patients in Acute Care, 10,737 or 74.71% of them were sent home. 288 of them had passed away, 1,457 went

  • Application Of Maslow's Hierarchy Of Needs Theory

    1763 Words  | 8 Pages

    Maslow's Need Hierarchy Theory The first content theory is one of the most popular theories of motivation and was developed by Abraham Maslow. His theory focused on the psychological needs of employees and is based on two principles. He proposed that individuals are "wanting beings" and that they are motivated to satisfy certain types of needs. The second premise of Maslow's theory is that individual needs are arranged in a hierarchy of importance. Maslow's theory suggests that when a lower level

  • Radio Show Evaluation

    912 Words  | 4 Pages

    After presenting the mid morning radio show. I am now going to evaluate my work including all aspects like the proposal, research, production, feedback and all of the strengths & weaknesses I had as a presenter. For my primary research I conducted a questionnaire. This was effective because it helped me find out that a radio show themed around gaming could be successful. I came to this conclusion because a lot of people were interested in my idea for this show. Also through secondary research I

  • SWOT Analysis: Delta Deli

    674 Words  | 3 Pages

    Delta Deli is a quick lunch stop shop primarily serving all-natural and top quality sandwiches geared toward busy people and their families, whose occupations make it difficult for them to enjoy a tasty, nutritious meal. Our store would also offer a selection of wraps and salads as alternative options, as well as chips, cookies, and crackers to complement the main meals. The products served at Delta Deli are made as if they were to be for family and friends to enjoy; however, not sacrificing the